Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
CUTTING WITHOUT REMOTE
• Ensure the remote cut switch is turned to OFF (0).
• Before cutting, ensure blades are properly installed.
• While in use, the tool can be set down on a dry subsurface or used as a handheld device. To stand the tool up on the ground, turn the
cutting head 180° so the front hand grip can be used as a base. If you want to use the tool as a handheld device, hold it securely using
both handles as shown.
1. Move the cable cutter with its cutting edges in right angle
to the cable. Do not attempt to make angled cuts as it will
damage the workpiece and blades.
2. Grasp handle(s) rmly. Move the slider switch into the
unlocked position. (1)
Pull and hold the trigger through the operation. (2)
An LED will light when the trigger is pulled.
When the cut is complete or the tool shuts o , release the
trigger.
Note: Workpiece may move slightly during the cut.
3. When the cut is complete, pull the release trigger to open the
blades. (3)
Pull the slider switch into the locking position. (4)
1
3
GB
2
4
Deutsch
English
9
Publicidad
Tabla de contenido
