Cutting Tips; Changing The Blades - Milwaukee M18 HCC75R Manual Original

CUTTING TIPS

• Do not attempt to make angled cuts as it will damage the
workpiece and blades.
• Lay the cable cutter on the cable, with its cutting edge at right
angle, up to the inner cutting end.
MAINTENANCE
Remove the battery pack before starting any work on the appliance.
Never open the cable cutter, removable battery or charger.
Check the cable cutter for any problems such as noise or jamming of moving parts that could be a ecting the tool.
Check the cutting tools for cracks and other signs of wear.
On completion of the work, clean and grease the cutting tools.
GB
Check that the cutting edges are sharp and replace worn cutting
jaws.

CHANGING THE BLADES

Replace the blades when they become chipped or damaged. Always replace blades as a set. Use only MILWAUKEE blades.
1. Push the trigger to close the blades slightly.
The retaining rings must be exposed.
2. Remove the battery pack and pull the
slide switch in position lock.
English Deutsch
12
• Cut clean material to extend the blade life. Wipe dirt and debris
from material and blades before beginning the cut.
• Activate the switch lock to secure the switch after completing the
cutting work.
49 162 774