Milwaukee M18 HCC75R Manual Original página 12

REMOTE CUTTING
• Before cutting, ensure blades are properly installed.
Once started, steps 1-4 must be completed with no more than 5
minutes between each step. If more than 5 minutes occurs, reset
(see step 7) and begin again.
• Ensure the remote cut switch is turned to OFF (0).
• Before cutting, ensure blades are properly installed.
• While in use, the tool can be set down on a dry subsurface or used as a handheld device. To stand the tool up on the ground, turn the
cutting head 180° so the front hand grip can be used as a base.
1. Hold the device by the tool handle as shown.
Move the cable cutter with its cutting edges in right angle
GB
to the cable. Do not attempt to make angled cuts as it will
damage the workpiece and blades.
2. Press the release switch and keep it pressed until the blades
are in contact with outer diameter of the cable. (2)
3. Turn ON (I) the remote cut switch on the tool.
Ö The tool's remote cut light will be steady red.
Deutsch English
10
1
2