Full Memory Clearing - FAAC TM2 X R COMPACT Manual Del Usario

FULL MEMORY CLEARING

The full memory clearing can be performed in two ways:
1) WITH THE REMOTE CONTROL
Tn: Already programmed remote control
+
A B
Tn
2) WITH THE WHITE WIRE
Do this operation only in case of emergency, if all remote controls are no longer ope-
rating.To delete the memory we have to access the white wire of the control unit.
The sequence of this operation is the following:
1) Disconnect the control unit from the power supply, via the main switch for
example.
2) Connect the white wire to the brown wire (phase) or to the blue wire (neutral).
3) Connect the control unit to the power supply. This will make the motor rotate
briefly in one direction.
4) Disconnect the control unit from the power supply for at least 4 seconds.
5) Connect the control unit to the power supply, which after about 4 seconds
will make the motor rotate briefly in one direction and then a longer one in the
opposite direction.
6) Disconnect the control unit from the power supply.
7) Separate the white wire from the brow/blue wire. Insulate the white wire, in an
appropriate way, before reconnecting the power supply.
At this point it is possible to proceed with the setting of the first remote control.
TM2 X R COMPACT
B
Tn
36
+
A B
Tn (4 sec)
A4518_6H81_Rev.A