Two-Stroke Oil; To Mix Gasoline And Two-Stroke Oil; Chain Oil - Zenoah GZ4350 Manual De Usuario

temperature and increased bearing load, which
results in serious engine damages.
• We recommend a higher octane when you do work
with continuous high revs, for example when you use
the limbing technique.
Ethanol fuel
Zenoah recommends commercial available fuel with
maximum 10% ethanol contents.
Running-in
Do not run the engine at unloaded full throttle for
extended periods during the first 10 hours.

Two-stroke oil

• For best results and performance use Zenoah two-
stroke oil, which is specially formulated for our two-
stroke engines. Mixture 1:50 (2%).
• If Zenoah two-stroke oil is not available, use a
different two-stroke oil of good quality that is
formulated for air-cooled engines. Consult your
servicing dealer when you select an oil.
• Do not use two-stroke oil for water-cooled outboard
engines, also referred to as outboard oil.
• Do not use oil intended for four-stroke engines.
Gasoline, l
5
10
15
20

To mix gasoline and two-stroke oil

CAUTION: There is a risk that small errors
influence the ratio of the mixture drastically
when you mix small quantities of fuel.
Carefully measure the quantity of oil to be
mixed to make sure that you get the correct
mixture.
14
1. Fill half the quantity of the gasoline to be used.
2. Add the full quantity of oil and mix (shake) the fuel
3. Add the remaining quantity of gasoline.
4. Carefully mix (shake) the fuel mixture and fill the fuel
5. Empty and clean the fuel tank if you do not use the
Note: Do not mix fuel for more than 1 month at a time
and always mix gasoline and oil in a clean container
intended for fuel.

Chain oil

All Zenoah chainsaws have an automatic chain
lubrication system. On some models the oil flow is also
adjustable.
Chain oil must show good adherence to the saw chain
and also keep its flow characteristics during warm
summer and cold winter weather.
The chain oil from Zenoah has a vegetable oil base and
is also biodegradable. We recommend you to use of our
chain oil for maximum saw chain life and to minimise
environmental damage. If this chain oil is not available,
Two-stroke oil,
we recommend you to use a standard chain oil.
l
The fuel runs out before the chain oil from the two tanks.
2% (1:50) This is a safety feature and it is necessary that you
follow the requirements below:
0,10
•
0,20
0,30
0,40
•
•
mixture.
tank of the product.
product for some time.
Use an oil of the right grade (suitable viscosity
range) to agree with the air temperature. If the oil is
too thin it will run out before the fuel. In temperatures
below 0°C (32°F) some oils become too viscous.
This can cause the oil pump to overload and result in
damage to the oil pump components.
Adjust the carburetor as recommended. A lean
mixture causes the chain oil tank to empty before the
fuel tank.
Use the recommended cutting equipment. A guide
bar that is too long will use more chain oil.
WARNING: Do not use waste oil! Waste oil
is dangerous to you and the environment.
Waste oil also causes damage to the oil
pump, the guide bar and the saw chain.
WARNING: Deficiente lubrication of the
cutting equipment can cause the saw chain
to break, which can cause serious injury or
death.
320 - 007 - 06.12.2017