Symbols On The Product - Zenoah GZ4350 Manual De Usuario

9. Starter housing
10. Chain oil tank
11. Bar tip sprocket
12. Guide bar
13. Saw chain
14. Muffler
15. Chain brake and front hand guard
16. Front handle
17. Choke control
18. Throttle trigger
19. Air purge
20. Clutch cover
21. Oil pump adjustment screw
22. Product and serial number plate
23. Chain tensioning screw
24. Chain catcher
25. Spiked bumper
26. Guide bar cover
27. Combination spanner
28. Operator's manual

Symbols on the product

Careless or incorrect use of this product can
result in serious or fatal injury to the operator
or others.
Read the operator's manual carefully and
make sure you understand the instructions
before you use this product.
Always wear approved protective helmet,
approved hearing protection and protective
goggles or a visor.
This product is in accordance with
applicable EC Directives.
Noise emission to the environment
according to the EC Directive. The product's
emission is specified in the Technical data
chapter and on the label.
Both of the operator's hands must be used
to operate the chainsaw.
Never operate the chainsaw holding it with
one hand only.
320 - 007 - 06.12.2017
Never let the guide bar tip come in contact
with any object.
Warning! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Chain brake, activated (right). Chain brake,
not activated (left).
Choke lever in "open position".
Choke lever in "closed position".
Air purge.
Refuelling.
Chain oil fill.
yyyywwxxxxx
Note: Other symbols/decals on the product refer to
certification requirements for certain markets.
Adjustment of the oil
pump.
The rating plate showing
serial number. yyyy is the
production year, ww is the
production week.
3