EMAK RIDER Manual Del Usuario página 49

ENG 4 SAFETY
6) Do not carry passengers.
7) The operator of a machine must carefully follow the driving instructions, particularly:
– the need for care and concentration when using machines;
– that control of a machine sliding on a slope will not be regained by the application of the
brake.
The main reasons for loss of control are:
– insufficient wheel grip;
– being driven too fast;
– inadequate braking;
– the type of machine is unsuitable for its task;
– lack of awareness of the effect of ground conditions, especially slopes;
8) The machine is equipped with a series of safety microswitches and devices which must
never be removed, altered or tampered with. Removing these devices invalidates the war-
ranty and the manufacturer declines any responsibility.
B) PREPARATION
1) While mowing, always wear substantial footwear and long trousers. Do not operate the
equipment when barefoot or wearing open sandals.
2) Thoroughly inspect the area where the equipment is to be used and remove all objects
which may be thrown by the machine (stones, sticks, metal wire, bones, etc.)
3) WARNING: DANGER! - Engine fuel is highly flammable:
– store fuel in containers specifically designed for this purpose;
– refuel using a funnel and outdoors only. Do not smoke while refuelling or whenever
handling the fuel;
– add fuel before starting the engine. Never remove the cap of the fuel tank or add fuel
while the engine is running or when the engine is hot;
– if fuel is spilled, do not attempt to start the engine but move the machine away from the
area of spillage and avoid creating any source of ignition until the fuel has evaporated and
the fumes dispersed;
– replace caps of all fuel tanks and containers securely.
4) Replace faulty silencers.
5) Before using, always carry out a visual inspection, particularly of the blade, seeing that
the screws and cutter assembly are not worn or damaged. Replace a worn or damaged
blade and screws as a set to preserve balance.
6) Before mowing, attach the discharge opening guards (grass-catcher or stone-guard).
C) OPERATION
1) Do not operate the engine in a confined space where dangerous carbon monoxide
fumes can collect.
2) Mow only in daylight or good artificial light.
3) Avoid operating the equipment in wet grass, where feasible.
➤
4) Before starting the engine, disengage the blade, shift the gear lever ( for mechanical
➤
drive models) or the speed change lever ( for hydrostatic drive models) into neutral and
engage the parking brake.
5) Do not use on slopes of more than 10° (17%).
6) Remember there is no such thing as a "safe" slope. Travel on grass slopes requires
particular care. To guard against overturning:
– it is advisable to use a front counterweight (supplied on request);
– do not stop or start suddenly when going up or downhill;
➤
– engage clutch slowly, always keep the machine in gear ( for mechanical drive
models) or engage the speed change lever slowly both for forward and reverse movement (
➤
for hydrostatic drive models), especially when travelling downhill;
– machine speeds should be kept low on slopes and during tight turns;
– stay alert for humps and hollows and other hidden hazards;
– never mow across the face of the slope.
7) Stop the blade rotating and put the cutting deck into the highest position before cros-