Connecting The Battery - EMAK RIDER Manual Del Usuario

ENG 10
Push the pin in using a hammer, ensuring that it comes completely through to the
opposite side.
NOTE
an awl or a screw-driver of the same size as the pin to push it in the last part.
FITTING THE SEAT
The seat (1) is supplied attached to a
support bracket (2) on which has been fit-
ted a micro-switch (3). Fit the bracket to
the supports (4) using the screw pins (5)
supplied, fully tightening the relative nuts
(6).
WARNING!
!
from the general wiring (8) to ensure that the safety device works, and
then fasten the wire with the wire-holder (9).

CONNECTING THE BATTERY

The battery (1) is situated in a compart-
ment under the steering wheel and is rea-
ched by removing the plastic cover (2)
held on by two screws (3).
Connect the two red cables (4) to the
positive terminal (+) and the three black
cables (5) to the negative terminal (–)
using the supplied screws and following
the illustrated sequence.
Recharge the battery according to the
manufacturer's instructions.
To avoid damaging the steering wheel with the hammer, use
Connect the micro-switch socket (7) to the one coming
UNPACKING AND ASSEMBLY
2
3
7
8
6
5
4
3
1
5
1
9
4
2
4