EMAK RIDER Manual Del Usuario página 81

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENG 36
grade grinding wheel and check the
balance by holding the blade up with a
round 18 mm diameter bar inserted in the
central hole.
To ensure that it works properly without
unusual vibrations any imbalance
between the two parts of the blade must be below one gram.
This can be easily ascertained by putting a one gram weight on the lightest end of
the blade. If it tends to go below the balanced position it means that the balance
is correct, while if it stays up then the other end will have to be made lighter.
WARNING!
!
never try to repair it! ALWAYS USE MANUFACTURER'S GENUINE SPARE
BLADES
!
WARNING!
!
sequence, making sure that the bla-
de's wings are facing towards the
interior of the cutting deck and that
the concave part of the cup spring (1)
is pressing against the blade. Fully
tighten the fixing screw (2). If the
shaft hub (3) came off when disman-
tling the blade, make sure that the
key (4) is firmly in its right position.
Ø 18 mm
A damaged or bent blade must always be replaced;
When re-fitting the blade, always follow the indicated
1 g
1 g
1 g
1
2
MAINTENANCE
RIGHT!
4
3
1
2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ef72c/12,5mEf72c/12,5hOm72c/12,5mOm72c/12,5h

Tabla de contenido