How To Use The Machine; Directions Before Starting - EMAK RIDER Manual Del Usuario

HOW TO USE THE MACHINE

5. HOW TO USE THE MACHINE
DANGER!
!
FOR DAMAGE AND INJURIES TO OTHERS. Before using the machine,
read the safety requirements shown in chapter 2, paying particular atten-
tion to driving and cutting on slopes. It is the user's responsibility to
assess the potential risk of the area where work is to be carried out, as
well as to take all the necessary steps to ensure safe working, particularly
on slopes or rough, slippery and unstable ground. This machine must not
be used on slopes greater than 10° (17%).
WARNING!
!
ground (max. 10°), fit counterweights (supplied on request) to the front
part of the frame to improve stability at the front and reduce the chance of
tipping up.
IMPORTANT
chapter 4.

5.1 DIRECTIONS BEFORE STARTING

S
EAT ADJUSTMENT
The seat is held by four screws (1) which have to be loosened for changing the
position of the seat which is done by sli-
ding it along the slots in the base.
When you have got in a comfortable posi-
tion, fully tighten the four screws.
R
EFUELLING
NOTE
are indicated in the engine booklet.
To reach the oil level dipstick, lift up the seat and open the hatchway beneath.
REMEMBER THAT THE USER IS ALWAYS RESPONSIBLE
If the machine is likely to be used mostly on sloping
All references regarding the positions of controls are shown in
The oil and fuel to use
1
1
ENG 17