Remote Control - S&P ARTIC TOWER M Manual De Instalacion E Instrucciones De Uso

By selecting this sequence, the fan will run at average speed with oscillation
for 6 hours. After this time the fan stops automatically.
-----------------------------------------------------------------------------------------

Timer OFF + ON: The fan is always in ON mode, you must first program the
TIMER OFF and then TIMER ON.
Once the programmed time has elapsed as TIMER OFF, the fan will stop and
remain on standby mode, then and once the programmed time has elapsed as
TIMER ON, the fan will automatically start at slow speed.
Example ------------------------------------------------------------------------------
Selecting this sequence, first the fan will stop after 4 hours and then put on
hold 1 hour.
Then it will run at slow speed with oscillation.
-----------------------------------------------------------------------------------------
- The device does not have internal memory, which if you disconnect from the
ductwork, all programming will be lost.
d) Energy saving :
The unit includes an electronic energy saving system, which detects if the user has left
the unit working (in any speed and without the timer function programmed) for more than
8 hours. This system automatically stops the unit, leaving an LED indicator on the control
panel flashing. To reset, disconnect the unit from the electrical supply and then
reconnect, the unit will return normal.

5. REMOTE CONTROL

ARTIC TOWER E Model – (Fig.3)
- Ensure that the battery of the remote control is correctly located. When replacing the
battery make sure it is the correct type (CR2032 3V).
- Always point the remote control at the receiver located at the top front of the fan.
- Remote control can work at a distance from the receiver up to about 3 metres provided
no there are no obstacles in the way that could distort the signal.
- Do not drop or bang the remote control or expose it to humidity or leave it for long
periods in direct sunlight.
Timer ON
1H 2H 4H
Timer OFF
13
6H 8H