Mounting Steps - Lenze L-force E94AZRS0544 Instructions De Montage

Rfi filter
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

5
Mechanical installation
Standard mounting

Mounting steps

5.2.2
Mounting steps
Proceed as follows for the installation:
1. Drill M6 threaded holes in the mounting plate and attach screws and
washers.
Four M6 screw and washer assemblies or M6 hexagon socket screws
(property class 8.8) with washers.
Attach the screws loosely first.
2. Attach the filter to the prepared mounting plate.
Tighten the screws hand−tight.
3. Attach screws and washers to the threaded holes for fastening the
standard device on the filter.
Four screw and washer assemblies or hexagon socket screws
M6 x 20 mm with washers.
Attach the screws loosely first.
4. Attach the standard device to the filter and tighten the screws fully.
Observe the notes given in the documentation for the standard device.
Tightening torque: 8 Nm (70.8 lb−in)
5. If necessary, pre−assemble further units.
6. Align all units.
7. Screw all units tightly to the mounting plate.
Tightening torque: 10 Nm (88.5 lb−in)
40
l
SSP94FF603
EDK94AZRS6 DE/EN/FR/ES/IT 7.0

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

L-force e94azrs0954

Tabla de contenido