Mounting Steps - Lenze E94AZPS Serie Instrucciones Para El Montaje

4.2

Mounting steps

Proceed as follows for the installation:
1. Prepare M5 threaded holes on the mounting plate according to the
mounting grid.
2. When using footprint filters: Screw installation backplane and footprint
filter together.
–
Use screw and washer assemblies M5 x 20 mm or hexagon socket
screws M5 x 20 mm with washers.
–
Tightening torque: 3.4 Nm (30 lb−in)
3. Screw the installation backplane or footprint filter with installation
backplane onto the mounting plate. Do not yet tighten the screws.
–
Use M5 screw and washer assemblies or M5 hexagon socket screws
with washers.
–
The screw joint in the installation backplane may jut out no more
than 7 mm.
4. Repeat steps 2 and 3 with further installation backplanes which are
mounted side by side.
5. Align all installation backplanes.
6. Screw all installation backplanes/footprint filters onto the mounting
plate.
–
Tightening torque: 3.4 Nm (30 lb−in).
EDK94ZPS113 DE/EN/FR/ES/IT 6.0
Mechanical installation
l
Mounting steps
4
45