Installing The Infant Restraint And Base Using Vehicle Belt - Graco SnugRide Click Connect 35 LX Manual Del Usuario

Ocultar thumbs Ver también para SnugRide Click Connect 35 LX:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.2 Installing the Infant Restraint and
Base Using Vehicle Belt
1. Make sure vehicle is on level ground in
order to get the correct recline position
2. Place the base in a rear-facing
position on a forward-facing vehicle seat.
3. When using the base to install the infant
restraint, the lock-off is ALWAYS used to
secure both belts of the lap or lap/shoulder
belt.
Open the lock-off and route the vehicle belt
through the vehicle belt path and over the
lock-off
. Buckle the vehicle belt.
4. Make sure the buckle tongue goes into the
correct buckle
not be twisted or turned.
Lap Belt
. The seat belt should
Belts MUST go
under lock-off
28
.
Lock-off
Lap/Shoulder
Belt

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido