Installing The Child Restraint And Base Using Vehicle Belt - Graco SnugRIDE Click Connect 40 Manual

6.2 Installing the Child Restraint and
Base Using Vehicle Belt
1. Make sure vehicle is on level ground in order to
get the correct recline position.
2. Place the base in a rear-facing position
on a forward-facing vehicle seat.
3. Push recline adjustment buttons
into position 1 to access lock-off.
4. When using the base to install the infant
restraint, the lock-off is ALWAYS used to
secure both belts of the lap or lap/shoulder
belt.
Open the lock-off and route the vehicle
belt through the vehicle belt path and over the
lock-off . Buckle the vehicle belt.
Lap Belt
and slide
Belts MUST go
under lock-off
28
Lock-off
Lap/Shoulder
Belt