Troubleshooting; Safety Notices; Cause And Action - Caso VC8 Manual Del Usuario

17 Troubleshooting

17.1 Safety notices

17.2 Cause and Action

Error
Vacuum unit is not
functioning
The first weld on the
cut off piece of the roll
is not being carried
out.
A complete vacuum is
not being created in
the bag.
The bag is not being
welded correctly
The bag does not hold
the vacuum after it has
been welded shut
caso Vakuumierer VC8
This chapter provides you with important notices with regard to
operating the device. Observe the following notices to avoid
dangers and damages:
► Only qualified electricians, who have been trained by the
manufacturer, may carry out any repairs on electrical
equipment.
► Improperly performed repairs can cause considerable
dangers for the user and damages to the device.
In the event of a fault, an error code will appear in the display; it
describes the cause of the fault.
Possible cause
Power plug is not plugged in
Defective power cable or plug
Defective electrical socket
Roll is not positioned
correctly
The open end of the bag is
not completely inside the
vacuum chamber
The bag is defective
There is dirt on the welding
and the normal seals
The welding bar is
overheating so that the bag
melts
The bag is defective
Attention
► Plug in mains plug!
► Send device to Customer
Service
► Select another electrical
socket
► Follow the steps in the
chapter "Vacuum packaging
in a bag originating on the
roll"
► Position the bag correctly
► Select another bag
► Clean the seals and retry
correctly once they are dry
► Open the cover on the unit
and let it cool down for a few
minutes
► Select another bag; wrap
paper serviettes around any
sharp edges on the content
Rectification
61