Overload Indication; Preparation For Use - Unpacking; Measuring Procedures - Amprobe CR50A Manual De Uso

OVERLOAD INDICATION

Range overload is indicated by "1" in
the display with all other digits blanked.
Select the next higher range until a value is
displayed. If overload condition still exists in the
highest range, the measured value is beyond the
range of the meter. Overload indication is normal
in the OHMS range when the leads are not
connected to anything or when the measured
value is higher than the selected resistance range.

PREPARATION FOR USE - UNPACKING

Your package should include:
1 CR50A
1 Test lead set (one black, one red)
1 Pair of alligator clips
1 9V battery (installed)
1 Spare 0.1A/250V fuse (inside the case)
1 Holster
1 Warranty Card
1 User manual
If any item is damaged or missing, return to the
place of purchase for an exchange.

MEASURING PROCEDURES

General: When connecting or disconnecting test leads
to/from a circuit, always first turn off power to device
or circuit being tested and discharge all capacitors.
3