Assembling The Changer - Evenflo BabySuite Manual De Instrucciones

CONFIGURING THE BASSINET
2
C
D
E
D
E
3
G
G
F
C
G
G
4
C
H
4
Place the bassinet on the floor with tubes and sleeves facing
C
upward.
Note: Tubes are pre-installed on the bassinet and require only to be
connected.
Connect one set of tubes and together, as shown. Make
D E
sure they are securely connected. Repeat for the other set of
tubes.
WARNING
To prevent injury or death, NEVER configure the bassinet with a
child in the playard. ALWAYS remove the child from the playard
before you configure it as a bassinet.
Place the bassinet C into the playard F with the tube assemblies
on top, as shown.
Make sure all four hooks G are securely attached to the rails,
as shown.
Fasten the bassinet C to the playard using the zipper
side of the bassinet. Cover each zipper tab with its flap
shown.
I
I
H
5
J
B
A
H on each
, as
I
Connect an elbow tube A
tubes to make sure they are securely attached to each other.
Insert the end of tube assembly
Push the tube assembly
C
other opening, as shown.
Connect the other elbow tube
together securely with an audible click. Pull the tubes to make sure they are securely
attached.
To avoid serious injury or death:
• Check to ensure bassinet is fully secure by firmly pressing down on all four
corners of the mattress pad.
A
• DO NOT use bassinet with children over 15 lbs (6.8 kg). Discontinue use
when child begins to push up on hands and knees or can roll over.
• FALL HAZARD: To prevent falls, do not use this product when infant begins
to push up on hands and knees or has reached manufacturer's recommended
maximum weight, whichever comes first.
To use the mattress pad with the bassinet, place it on the bassinet,
A
cushion side up. Push down firmly on the mattress to attach the Velcro
straps.
Insert the six mattress straps
in the bassinet and fasten them to the Velcro tabs on the underside of the
bassinet. Make sure all six straps are properly secured to the bassinet.
Note: The mattress pad must always be used with the Velcro tabs facing
downward to secure the pad to the floor of the bassinet.
D
C
to the straight tube B . Make sure they snap together securely with an audible click. Pull the
into a corner opening on the changer , as shown.
C D
completely through the changer until it comes out of the
E to the tube assembly C . Make sure they snap
CONFIGURING THE BASSINET
WARNING
J on the mattress pad through the slots K
J
K

ASSEMBLING THE CHANGER

c
C
E
5