Sage Bambino Plus Guía Rápida página 11

PAGE HEADER..... OPERATING YOUR NEW APPLIANCE
SETTING THE MILK TEMPERATURE
The machine has 3 milk temperature settings;
1 Warm
2 Ideal
3 Hot
When turning on the espresso machine, the milk
temperature setting will default to the last
chosen setting. Press the MILK TEMP button
until the desired temperature is illuminated.
SETTING THE MILK FOAM
The machine has 3 milk foam settings;
1 Low
2 Medium
3 High
When turning on the machine, the milk foam
setting will default to the last chosen setting.
Press the MILK FOAM button until the desired
foam setting is illuminated.
NOTE
Prior to texturing milk, it is recommended
to momentarily purge the steam wand. To
do this press the STEAM button to start
purging and press it again to stop.
• Start with fresh cold milk.
• Fill the milk jug to between the min and
max position.
• Lift the steam wand and insert into the milk jug.
• Lower the steam wand, ensuring it is fully down.
• The milk jug must rest on the milk
temperature sensor located on the drip tray
and the milk should cover the steam wand tip.
MAX
MIN
3
2
1
3
2
1
3
2
1
3
2
1
Milk
should
cover
this part
• Press the MILK TEMP and MILK FOAM buttons
to select the desired settings.
• Press the STEAM button, the button will flash
while texturing.
• The milk texturing will stop automatically when
the selected milk temperature is reached.
• Lift the steam wand to remove the milk jug.
• Wipe the wand and tip with a clean damp cloth.
• Lower the steam wand to the down position and
the steam wand will automatically purge.
NOTE
Pressurised steam can still be released,
even after the machine has been switched
off. Children must always be supervised.
NOTE
When the machine creates steam, a pumping
noise can be heard. This is normal operation.
NOTE
Use only the supplied stainless steel
milk jug to froth milk using this machine.
The use of other containers may lead to
dangerous conditions.
EN
11