ESAB Origo Feed 304 PIPE Manual De Instrucciones página 19

N.B.:The total range of wire diameters that the wire feeder can hold is covered by
a roller set for diameters between 1.20 to 2.00 mm; each roller has 2 grooves,
each corresponding to a wire diameter.
The pressure rollers (top) and the feed (bottom) are geared between themselves,
being as such all impellers.
5) INSTALLATION
1) Connect the wire feeder to the power source associated through the cable of command.
2) Fix the welding cable connected to the terminal + power source in the quick connection placed in the rear
panel.
3) Install the welding gun.
4) Install the wire.
5) Install the feed rollers (see table 5.1) and the inlet and intermediate nozzles (see table 5.2) according to
the type and wire diameter to be used.
NOTE: The feed and pressure rollers are parts subject to wear in normal
operating system, and should be substituted whenever there are signs of wear
that can prevent the correct feeding of the welding wire feeder.
TABLE 5.1
Wire type
Cover
TABLE 5.2
Description
Intermediate Nozzle
Section 9 of this manual presents the complete list of components of the wire feeder mechanism.
Diameter (mm)
1.20 - 1.60
1.60 - 2.00
Wire diameter (mm)
1.20 - 1.60
1.60 - 2.00
Reference
0900121
0901204
Reference
0900368
0900896
19
Origo™ Feed 304 PIPE