Table For Cv - LGB 28445 Manual Del Usuario

Register Assignment
1 Address
2 Minimum speed
3 Acceleration delay
4 Braking delay
5 Maximum speed
8 Reset
13 Function F1 – F8 with alternative track signal
14 Function FL, F9 – F15 with alternative track signal
17 Expanded address, higher value byte
18 Expanded address, lower value byte
19 Multiple unit operation address
21 Functions F1 – F8 with multiple unit operation
22 Function FL, F9 – F15 with multiple unit operation
Bit 4: Braking mode voltage against the direction of travel
27
Bit 5: Braking mode voltage with the direction of travel
Bit 0: Direction normal/inverted
Bit 1: Number of speed levels 14/28(128)
29
Bit 2: Analog operation off/on
Bit 5: short / long address active
Alternative Formats
50 Bit 1: Analog DC
Bit 3: mfx off/on
Range Default Register Assignment
1 – 127 3
0 – 255 7
60
0 – 255 4
0 – 255 4
63
0 – 255 255
64
8 159
67 – 94 Speed table for speed levels 1 – 28
0 – 255 96
112
0 – 255 1
113
192 – 231 192
114
0 – 255 128
115
0 – 255 0
116 – 143
0 – 255 0
176
0 – 255 0
0/16 177
16
0/32
0/1
The factory settings for the CVs in function mapping are available online at
0/2 www.LGB.de as an appendix to the locomotive instructions.
6
Note:
0/4
0/32 At www.LGB.de, you will find at „Tools and Downloads" an extensive description of
the decoder as well as a tool that you can use to calculate different settings.
0/2
14
0/8
11
Multi-station announcement
Bit 0 – 3: Number of stations
Bit 4: Last announcement changes the sequence
Bit 5: Locomotive direction changes the sequence
Bit 6: Start for the sequence
Total volume
Threshhold for squealing brakes
Mapping lights in the front, mode
Mapping lights in the front, dimmer
Mapping lights in the front, cycle
On and Off Delay
Mapping phys. outputs, lights in the rear, Aux 1 – 6,
compare 112 – 115
Minimum speed in analog DC
Maximum speed in analog DC
Range Default
0 – 15
0/16 43
0/32
0/64
0 – 255 240
0 – 255 35
0 – 255
0 – 21 1
0 – 255 255
0 – 255 20
0 – 255 0
0 – 16
0 – 255
0 – 255 50
0 – 255 159