JUKI CP-180 Manual De Instrucciones página 32

(2) Constant-dimension stitching pattern
2
OFF
Sewing pattern
CD
3
OFF
4) Four different kinds of stitching patterns can be performed according to the combination of ON/OFF set-
tings of automatic reverse stitching (for start) switch 2 and automatic reverse stitching (for end) switch 3 .
5) Furthermore, the double reverse stitching mode can be specifi ed by operating double reverse stitching (for
start) switch 7 and double reverse stitching (for end) switch 8 .
6) If automatic thread trimming switch 6 is turned ON, the sewing machine will automatically perform
thread trimming after it fi nishes the predetermined number of stitches between C and D. (If the automatic
reverse feed stitching (for end) is selected, the sewing machine will automatically perform thread trim-
ming after it fi nishes the automatic reverse stitching (for end) even when the automatic thread trimming
switch is not selected.)
If automatic thread trimming switch 6 is turned OFF, operate the touch-back switch after the completion
of processes C and D. Then the machine runs at a low speed (stitch compensation operation).
Also, if the pedal is returned to its neutral position and depressed its front part again, the sewing can be
continued regardless of the setting of number of stitches.
7) If thread trimming prohibiting function 9 is chosen, the machine will stop with the needle up without per-
forming thread trimming.
8) If one-shot automatic stitching function !0 is chosen, the machine will automatically perform sewing at a
stretch, at the specifi ed speed by depressing the front part of the pedal.
7 2
8 3 1
ON OFF ON
A A
B B
CD CD CD
B
B
A A
OFF ON ON
4 5
1) Press constant-dimension stitching pattern
switch 1 on the control panel to select the
constant-dimension stitching pattern.
2) The constant-dimension stitching pattern is
selected. Now, the predetermined number of
stitches and the state of reverse stitching func-
tion are shown on the control panel.
3) To change the number of stitches of the process-
es in the constant-dimension stitching pattern,
change the number of stitches for processes C
and D by operating switches 5 for setting the
number of stitches for processes C and D. Select
the reverse feed stitching accordingly. To change
the number of reverse-feed stitches, operate
switches 4 for setting the number of stitches for
processes A and B.
Adjusting range : A, B = to 19 stitches
- 6 -
!0
6 9
C, D = 5 to 500 stitches