Storage; Troubleshooting - Silvercrest SFE 450 C1 Instrucciones De Uso

To clean the filters w, use the supplied nylon brush r:
■ Turn the lid of the pusher 1 until the arrow points to the opened lock
the pusher shaft . You can now remove the lid . The nylon brush r can be
found inside the pusher 1 . To re-close the lid, place it on the pusher so that
the arrow points to the opened lock
the closed lock
■ Hold the filter w (with the underside upwards) under running water and
clean it with the nylon brush r .
Colouring:
■ Some fruits or vegetables can permanently discolour parts of the juicer .
This is not damaging and does not impair the appliance in its functions .

Storage

If you do not intend to use the juicer for a long time, wrap the cable around the
cable retainer 0 on the underside of the juicer .

Troubleshooting

Faults
The appliance is
not working .
The motor stops
still while juicing or
it turns noticeably
more slowly or
unevenly .
The pulp is moist
and you obtain too
little juice .
The juice wells out
between the edge
of the lid 3 and
the juice tank 5 .
SFE 450 C1
. The lid now sits firmly in place .
Possible causes
The mains plug 8 is not
connected .
The appliance is not switched on . Switch the appliance on with
The clamps 4 are not secured .
The filter w is blocked .
You are working too fast .
The filter w is blocked .
You are working too fast .
The filter w or the juice tank 5
is blocked .
The speed setting is too high .
. Then turn it until the arrow points at
Possible solutions
Connect the appliance to
a mains power socket .
the On/Off switch 9 .
Close the clamps 4 .
Switch the juicer off immediately
and pull out the mains plug 8 .
Remove the blockage (see sec-
tion "Juicing") .
Work a little more slowly .
Clean the filter w (see section
"Cleaning and Care") .
Work a little more slowly .
Clean the filter w and
the juice tank 5 (see section
"Cleaning and care") .
Use the on/off switch 9 to
select speed level 1 .
GB │ IE
on
│ 31 ■