Astralpool ANA01 Manual De Instalación Y De Utilización página 19

3) Position the pipe saddle clamp on the dis-
charge circuit between the filtration box and the
devices for heating, adjustments, chlorine pro-
duction and product injection. If there is continu-
al air intake, place the pipe saddle clamp with the
check valve underneath or on the side. Connect
this pipe saddle to the transparent crystal tube
(suction line).
4) Screw in the feed connection and make it
water-tight by following the direction of flow indi-
cated by the arrow on the check valve.
5) Position a second pipe saddle clamp on the
waste line (sand filter model) or else connect up
to the closest waste outlet.
6 - Installing the chamber
Plan for enough space on the
removable side of the chamber
so as to be able to detach the
electrode. If the chamber is
installed on a by-pass, make
sure that at least 80% of the
flow goes through it.
To it, connect and adjust the black waste pipe
which protrudes from the machine. Be careful not
to pinch or crimp the pipes when doing this.
6) Connect the Amichloryte container's dis-
charge pipe to the P2 pump and loosen the pipe
saddle if necessary. Electrically connect the
machine to the pool pump's servo-control switch.
Make sure that the machine switches off at the
same time the filtration does.
7) Connect the salt chlorinator or dosage pump
to the connection box provided and suited for the
model purchased (see chamber installation). If
it is a dosage pump, please refer to the
"dosage pump/solenoid valve" configuration
example.
Affix the chamber onto the piping
returning to the pool, after the filter and
after the preheater or start of the surge
tank.
The water must circulate from the T-
connection towards the reduction (fol-
low the direction of the arrow on the
chamber); the water flow must impera-
tively circulate between the plates
(electrode).
18