Adding Salt - Astralpool ANA01 Manual De Instalación Y De Utilización

11 - Switching on
Activate the filtration and turn on the machine
(position: "ON").
1
11. Salt
Pour the salt directly into the pool, with the filtra-
tion running.
Do not turn the machine on until the salt has
been completely dissolved.
2
11.

Adding Salt

Check the salt concentration. If it is less than 4 g/l
add salt by using the following calculation:
Q = (4-T) x V
Q = quantity of salt to add, in kg
4 = correct salt concentration
T = concentration recorded in pool
V = pool volume in m
Always turn off the machine before adding any
products whatsoever.
Wait until the salt is dissolved before turning the
machine back on again.
3
11. Stabilizer
The use of a stabilizer, 20 g/m
ly recommended in very hot weather to avoid
chlorine evaporation and to lessen corrosion.
Maximum concentration: 50 g/m
NOTE: Too LOW a concentration of stabilizer
will double chlorine consumption in your
pool. On the other hand, too HIGH a concen-
tration of stabilizer will cancel out the chlo-
rine effect!
If the pool treatment is done by means of
chlorine tablets, measure the concentration
of stabilizer present in the water. If the con-
centration exceeds 50 g/m3, replenish part of
the water before adding the salt.
4 After a time-lag period of approximately 15
11.
seconds, begin the amychlorite priming by push-
ing on for 1 second. If necessary, carry
out a manual priming by continuously pressing
on for 15 seconds.
3 .
3 in water, is strong-
3
5 The green led light will blink until reagent
11.
has been detected in the analysis chamber, and
then it will remain lit once the priming is finished.
6 When the green led light has stopped
11.
blinking, turn off the machine (position "OFF"),
then turn the machine back on again. It may be
necessary to do two or three analyses in order to
determine the real chlorine concentration of the
pool.
7 Adjust the desired chlorine concentration
11.
c g
depending on your pool's configuration. Press on
g
and on , and the red led will move clock-
wise. Let go of the
the chosen concentration point.
To launch a forced analysis, press on
8 The machine carries out an analysis of
11.
your pool's chlorine concentration, and manages
and triggers chlorine production, in order to reach
the selected set point.
- If the chlorine measurement is below
the requested concentration, the green
comes on and the chlorine concentration starts
up.
(Note: do not forget to turn on the salt chlori-
nator or dosage pump).
- If the chlorine measurement is above
the requested concentration, the
and the chlorine production devices do not work.
11. 9 Adjusting the change of
polarity time
Your machine has been factory-set for a change
of polarity every 4 hours. It is possible to modify
this change of polarity time, from 1 to 99 hours,
depending on the total hardness of the water
(TH). (See paragraph
As an indication :
> 50° TH
between 50°TH & 20°TH ≅ 4 to 20 hours
< 20°TH
If the electrode scales-up, you should shorten the
change of polarity time.
21
button when it has reached
c
and
led is off,
10
)
≅ 3 hours
≅ 20 to 99 hours
g
.
led