Troubleshooting - Ratio SDS125M Manual Del Usuario

tRoUbLesHootinG

problems
Very high spark
generation
High wear on certain
parts of the saw blade
Saw blades fracture
Teeth broken off
38
possible Causes
Defective teeth on the saw blade
Feed speed too low
Blunt saw teeth
Feed speed too high
Damaged teeth
Blunt teeth
Cut is not parallel or perpendicular to
the working surface
Damaged teeth
Feed speed too high
Blunt teeth
Saw blades bent
Saw blades burned
Feed speed too high
The material being cut is too hard
Teeth damaged by excessive force
Saw blades incorrectly fitted
Saw blades burned
Corrective Action
Fit new saw blades
Increase feed speed
Fit new saw blades
Reduce feed speed
Fit new saw blades
Fit new saw blades
Keep the saw parallel to the
working surface
Fit new saw blades
Reduce feed speed
Fit new saw blades
Fit new saw blades
Fit new saw blades
Reduce feed speed
Replace saw blades
Replace saw blades
Replace saw blades and follow the
fitting instructions precisely
Replace saw blades