Environmental Protection - Ratio SDS125M Manual Del Usuario

Guide the saw blade at a diagonal through the
cutting surface.
rectangular tubing (See E4)
Guide the saw blade from corner to corner.
u-shaped sections (See E5)
Guide the saw blade from corner to corner.
Shaped plate (See E6)
Plate must always rest on three supports one of
which must be next to the cut.
Always position the saw blade perpendicular
and guide it through the material until it
reaches the bottom end. (See E7)
Spiral tubing and longitudinal sawing(See E8)
Guide the saw blade through the workpiece
until it projects by just 10 mm. Do not place the
complete saw blade into the material. Then move
the saw forwards or backwards through the
material.
Thin plate (See E9)
Ensure that the saw blade does not project out
of the bottom of the workpiece by more than 10
mm.
maintenance
Before maintenance and cleaning, please
always remove the plug from power source. The
retracting blade guard must always be able to
move freely and retract automatically. Keep the
area around the retracting blade guard clean.
Remove dust and chips by blowing out with
compressed air or with a brush before storage.
Saw blades can be protected against corrosion
with a thin coat of acid-free oil. Before use, the
oil must be removed again; otherwise the wood
will become soiled. Resin and glue residue on
the saw blade produces poor cuts. Clean the saw
blade immediately after use.
Keep the ventilation openings clear and clean the
product regularly. If something unusual occurs
during use, switch off the supply and disconnect
the plug. Inspect and repair the tool before using
it again. The repairs must be carried out by a
qualified technician.
Repair of the tool must only be carried out by a
qualified repair technician.
Repair or maintenance by unqualified personnel
can lead to a risk of injury.
Use only identical spare parts for repairing a
tool. Follow the instructions in the maintenance
section of this user manual.
cLeaninG
Clean the housing only with a damp cloth-do not
uses any solvents! Dry thoroughly afterwards.
Store the machine, operating instructions and
where necessary the accessories in the original
packaging. In this way you will always have all
the information and parts ready to hand. Pack
the device well or use the original packaging in
order to avoid transit damage. Always keep the
machine in dry place.
enviRonmentaL
pRotection
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authorities or retailer for recycling
advice.
37