Section 3. Installation Instructions; Materials And Tools; Installation Requirements - Zodiac Pool Systems Jandy AquaPure Serie Manual De Instalación Y Funcionamiento

Page 10
Section 3. Installation Instructions
FOR YOUR SAFETY: This product must be installed and serviced by a professional pool/spa service technician
as described on the front cover of this manual. The procedures in this manual must be followed exactly. Failure to
follow warning notices and instructions may result in property damage, serious injury, or death. Improper installation
and/or operation will void the warranty.
EQUIPMENT UNDER PRESSURE: Always turn pump off prior to installing or servicing the Jandy
Ei TM chlorine generating device. Your pump/fi lter system is operated under pressure and the pressure must be
released before you begin work. Please see your pump/fi lter owner's manual for further instructions.
Disconnect power to the system at the main circuit breaker before performing this procedure to avoid risk of
electric shock which can result in property damage, severe injury or death.
Before you begin your installation, please check that you have the right tools and a suitable location to install the
power pack and cell. Please ensure that you have read and understood the Important Safety Instructions section.

3.1 Materials and Tools

Installation Materials Furnished
• Pipe Spacer - for 40 mm (1½ in.) pipe
• Hole Saw
• Screw Set (includes wall plugs)
• Installation and Operation Manual

3.2 Installation Requirements

The Jandy AquaPure Ei chlorine generating device must be installed
horizontally with the cell above the pipe to avoid buildup of fl ammable
gases which can result in FIRE OR EXPLOSION.
The installation requirements for the Jandy AquaPure Ei chlorine
generating device are as follows:
• The power pack must be be installed at least 1.5 m (5 ft.) vertically off
the ground.
• In the U.S., the power pack must be be installed at least 1.5 m (5 ft.)
from the inside wall of your swimming pool or spa; in Canada, the power
pack must be be installed at least 3 m (10 ft.) from the inside wall of your
swimming pool or spa.
• The cell must be installed on a 0.4 m (1 ⅓ ft.) horizontal length
of pipe after the heaters, pumps, and fi lters, as the last piece of
equipment in the circulation plumbing system just before the pool
(see Figure 3).
• The cell must be installed no more than 4.6 m (15 ft.) from the power
pack (see Figure 3).
• It is recommended that the cell be installed 0.25 m (10 in.) from any
90° elbow.
WARNING
WARNING
Tools Needed for Installation
• Cordless Drill (or Power Drill)
• 6 mm (15/64 in.) Hammer Drill Bit (only necessary to drill into
brick or concrete)
• Pencil or Marking Pen
• Phillips Head Screwdriver or Phillips Head Drill Bit
WARNING
®
4.6 m (15 ft.) MAX
Figure 3.

Installation Requirements

AquaPure
®
Power
Pack
Cell