Water Flow Arrows; Cell Attached; Locking Ring; Locking Ring Level - Zodiac Pool Systems Jandy AquaPure Serie Manual De Instalación Y Funcionamiento

Page 12
10. Verify the gasket is attached to the upper clamp. The curved side of the gasket must be pointing down so that it
will create a seal with the pipe.
11. Secure the clamps, pipe spacer, and gasket around the pipe as shown (see Figure 10) making sure the fl ow
arrows on the clamp point in the direction of the water fl ow (see Figure 11). Make sure the two (2) clips on the
sides of the clamp are snapped into place.
12. Insert the o-ring into the channel on the clamp and then attach the cell (see Figure 11 and 12).
Figure 10. Attaching Cell Clamps
13. Position the locking ring in proper alignment, making sure the bump aligns with the top thread (see Figure 13).
14. Screw down the locking ring to the threaded clamp using the locking ring tool (see Figure 14).
NOTE Ensure the locking ring is level when engaging the threading clamp (see Figure 15).
NOTE: The Upper
Align the bump with
Clamp is not shown
the high thread on
in this diagram but it
the lower clamp.
should be installed.
Figure 13.

Locking Ring

Alignment
15 Securely connect the cell leads to the like colored terminals (see Figure 16).
16. Attach the terminal cap (see Figure 17 ).
Black
Red
Figure 16. Connecting Cell Leads
O-Ring
Figure 11.
Figure 14.
Red
Blue
Figure 17.

Water Flow Arrows

Locking Ring
Tool
Locking Ring

Attaching Terminal Cap

The groove
must be on
the inlet side
Figure 12.

Cell Attached

Figure 15.

Locking Ring Level

x