Section 1. Important Safety Instructions - Zodiac Pool Systems Jandy AquaPure Serie Manual De Instalación Y Funcionamiento

Section 1. Important Safety Instructions
READ AND FOLLOW ALL INSTRUCTIONS
All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
EQUIPMENT UNDER PRESSURE: Always turn pump off prior to installing or servicing the power pack or cell.
Your pump/fi lter system is operated under pressure and the pressure must be released before you begin work.
Please see your pump/fi lter owner's manual for further instructions.
To reduce the risk of electric shock, fi re or injury, service should only be attempted by a qualifi ed pool service professional.
Jandy ® AquaPure ® Ei TM
Contrary use could affect performance, void warranty, and may result in property damage, serious injury, or death.
• Operating a chlorine generator without water fl owing through the cell may cause a build up of fl ammable
gases, resulting in fi re or explosion.
• Keep equipment out of reach of children.
• A damaged supply cord should only be replaced by the manufacturer, service agent or electrician.
• When installing and using this electrical equipment, always follow basic safety precautions.
• Before performing installation, disconnect all power.
• Connect to a circuit that is protected by a ground fault circuit interrupter (GFCI).
• Do not install within an outer enclosure or beneath the skirt of a hot tub or spa.
Installation must be done in accordance with the National Electrical Code ("NEC" or NFPA-70) in the US, the Canadian
Electrical Code ("CEC" or C22.1) in Canada, and/or any other local and national installation codes.
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Connect only to a branch circuit that is
protected by a ground-fault circuit-interrupter (GFCI). Contact a qualifi ed electrician if you cannot verify that the circuit
is protected by a GFCI. Make sure such a GFCI should be provided by the installer and should be tested on a routine
basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should
be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the pump
without the test button being pushed, a ground current is fl owing, indicating the possibility of electrical shock. Do not
use the device. Disconnect the device and have the problem corrected by a qualifi ed service representative before
using.
A wire-binding screw for grounding (labeled
connect the ground wire to the grounding points in the power pack and of your electric service or supply panel with a
conductor equivalent in size to the circuit conductors supplying this equipment.
The power pack must be interlocked/interconnected with the pool pump motor power source to ensure that the
chlorinator only operates when the pool pump is operating.
Operating the Jandy AquaPure Ei chlorine generating device without water fl ow through the electrolytic cell can cause a
buildup of fl ammable gasses which can result in FIRE OR EXPLOSION.
chlorine generating devices are designed for domestic (residential) swimming pool use only.
) is provided inside the power pack. To reduce risk of electric shock,
WARNING
WARNING
WARNING
WARNING
WARNING
Page 5