Bradley Terreon TDB3104 Manual Del Usuario página 13

Installation
Adaptive infrared assembly for B drain and H drain units
5b
without Tie Pipe option
A
Install hemmed end (not sharp end) of
support tube with gasket onto bowl.
Place sprayhead with 3/8" tubing onto
support tube. Run the tubing down through
B
the support tube and connect to valve tube
connector. Make sure the spray holes point
away from the wall.
1-1/2" Vent Pipe
IR Module Assembly
Tie Bar Pre-Pack
Support Tube
STD (S57-005)
TAS/JUV (S57-006)
Support
Tube Gasket
(125-011)
Semi-Circ. Bowl Pre-Pack
(S45-1523)
Standard Pedestal Assembly
(S17-259)
TAS Pedestal Assembly
(S17-345)
Bradley • 215-1078 Rev. T; ECN 12-00-004
(S50-367)
(S45-056)
Valve Assembly
Insert the 1-1/2" vent pipe (supplied by
C
installer) down through the support tube and
thread into vented trap.
Sprayhead
Top Cover
(107-185 (B))
(107-048 (H))
Module
Cover
Sprayhead
(S05-054B)
IR Module Wires
Terreon
Bradley Rep for assistance)
Vented Trap
Access Panel
(186-1456)
B/H
(B shown)
TDB3104, WF3204
IR Module
Assembly
Supply Tube
Section View of
B/H Unit Assembly
Drain
(S45-273)
Semi-Circular Bowl
®
(Part No. Varies with color
of bowl. Contact your local
(111-024)
1/15/2013
Cover
Tie Bar
13