Switching On And Off; Selecting The Correct Rotational Speed And Sanding Belt - Parkside PEBS 600 Instrucciones De Utilización Y De Seguridad

DAngEr oF FIrE FroM FLyIng SPArKS!
Do not use any form of dust extraction (dust box
or vacuum extraction device) if you are sanding metal.
connection:
j
Push the adapter for external vacuum extraction
into the adapter port
12
use the reducer piece
piece into the adapter for external vacuum ex-
traction .
12
j
Slide the hose of a suitable dust extraction de-
vice approved for that purpose (e.g. a workshop
vacuum cleaner) on to the adapter for external
vacuum extraction
12
if used.
removal:
j
Pull off the dust extraction device hose.
j
Pull off the adapter for external vacuum extrac-
tion (with the reducer piece
12
operation
Q

Switching on and off

Q
When operating the belt sander you can select
between intermittent or continuous operation mode.
to switch on intermittent operation mode:
j
Press the ON / OFF switch
to switch off intermittent operation mode:
j
Release the ON / OFF switch
to switch on continuous operation mode:
j
Press the ON / OFF switch
pressed, then press the locking knob
to switch off continuous operation mode:
j
Press and then release the ON / OFF switch
5
. If it is necessary to
9
, push the reducer
13
with the reducer piece
13
, if used).
13
3
.
3
.
, and keep it
3
4
.
3
Preparing for use / Operation
Selecting the correct rotational
Q
speed and sanding belt
You can select the belt speed using the belt speed
adjuster wheel even whilst the sander is running.
1
The optimum belt speed depends on the workpiece
and the workpiece material. Always confirm the
best speed by carrying out a small test. The follow-
ing table lists some recommended values to help
you determine the optimum speed.
Material / type of
work
,
Coarse finish
(Grit grade)
Fine finish (Grit grade) 240
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 180
Preselected rotation
speed
Material / type of
work
Coarse finish
(Grit grade)
Fine finish (Grit grade) 150
Preselected rotation
speed
Material / type of
work
Coarse finish
.
(Grit grade)
Fine finish (Grit grade) ––
Preselected rotation
speed
Softwood
60
high (5-6)
Hardwood
60
high (5-6)
chipboard
60
high (5-6)
removing paint /
varnish
60
high (5-6)
GB/MT 41