Switching Levels; Preparing For Hot Lamination - UNITED OFFICE ULG 300 B1 Instrucciones De Uso

Switching levels

Selector switch 8
position
COLD
NOTE
► For high-gloss photos, you should choose the setting "125" as well as well
as the corresponding laminating pouch thickness .

Preparing for hot lamination

♦ Place the pouch guide rail 1 into the holes designed for this purpose on the
rear of the laminator .
♦ Fold out the document supports q so that the documents are pulled into the
slot for manual pouch insertion 5 straight .
♦ Insert the plug of the laminator into a mains power socket .
♦ Set the ON/OFF switch 7 to "ON" (I) .
♦ Set the selector switch for hot and cold lamination 8 to "HOT" (I) .
♦ Set the pouch thickness switch e to the desired pouch thickness (see also
section Switching levels) . The red ON/OFF indicator lamp 9 lights up .
The laminator heats up to operating temperature .
As soon as the green indicator lamp "Ready" 6 lights up, the laminator has
reached its operating temperature .
NOTE
► The attainment of the operating temperature is indicated by the lighting
up of the green indicator lamp "Ready" 6 . For a more uniform laminating
result we recommend, especially for thinner foils (below 125 µm), and
after adjustment to a different foil thickness, that you first wait an additional
2–3 minutes before starting the lamination .
► It is possible that the green indicator lamp "Ready" 6 occasionally goes
out and lights up again . This means that the appliance is maintaining the
temperature and has heated up again a little . This is not a malfunction of
the appliance!
♦ Place the document to be laminated into a laminating pouch of the appropriate
size .
ULG 300 B1
Pouch thickness
switch e position
HOT
HOT
Laminating pouch
80
125
125
thickness
> 60–80
85–125
up to 200
GB │ IE │ 23 ■