Beper 40.742 Manual De Instrucciones página 10

5 in 1 hair and beard trimmer set Use Instructions
Charging of the appliance
This appliance can be used with or without the adaptor. It is thus possible to keep using the appliance even when
the battery runs out during operation, by simply plugging it into the wall socket.
In order to do this, make sure that the appliance is turned off before plugging it into the wall socket, and wait
approx. 1 minute before turning the appliance on again.
To charge the appliance:
a. You can connect the adaptor directly to the appliance, by inserting the connection pin in the connector found
at the bottom of hair clipper;
Or
b. You can connect the adaptor to the standing and charging base, by inserting the connection pin inside the
hole found in the hair clipper housing, and blocking it with the cable stopper, to prevent it from detach or falling.
Once the connection pin is fixed, simply place the hair clipper on the standing base, to start charging the ap-
pliance.
When the adaptor is plugged into the wall socket, the LED indicator on the display of the hair clipper turns red,
and stays on until the battery is charged.
When the LED indicator turns green, the appliance is fully charged and ready to use.
Complete charging of the appliance takes approximately 90 minutes, for 60 minutes of continuous operation
time.
Instructions for use
The appliance features 5 interchangeable heads, with different functions:
Hair clipper head
This head is used for cutting hair and beard. The 4 guiding combs included in the set allow to cut and trim hair
and beard at 4 different lengths: 3, 6, 9 and 12 mm.
Carefully brush hair and beard before starting to trim them.
Choose the guiding comb for the desired length, and insert it on to the hair clipper head, making sure that it it
well fixed before switching on the appliance.
Note: make sure that the appliance is turned off and unplugged from the wall socket before inserting the
guiding comb on to the blade.
For best result, it is better to cut hair and beard following the direction of growth.
For a more precise trimming, you can remove the guiding comb from the hair clipper head, and cut your hair and
beard adjusting the height of the blades using the cutting length selector found on the hair clipper. This selector
allows to adjust blades to 3 different lengths: 0,8 mm – 1,1 mm – 1,4 mm.
Hair and beard trimmer
This head is used for trimming beard and hair. The guiding comb included in the set allows to choose 4 different
trimming lengths: 4, 5, 6 and 7 mm.
To use the trimmer, insert the guiding comb on the blade and proceed as detailed in the previous paragraph.
Note: make sure that the appliance is turned off and unplugged from the wall socket before inserting the guiding
comb on to the blade.
Precision trimmer
This head is used for maximum precision trimming of hair and beard.
Nose/ear trimmer
This accessory is used for nose and ears; by simply and carefully introducing the trimmer into nostrils and ear
holes, this accessory allows to quickly trim and/or remove unwanted hair from these areas.
Note: do not insert the trimmer too deeply into nostrils and ear holes, to avoid any damage and injury.
Shaver head
This head is used as a classic shaver, to mainly shave face and neck.
It is better to clean and dry your skin before shaving.
For best result, keep the appliance at a 45° angle, gently leaning the head on your skin, to limit any possible
rash or redness.
Note: to remove heads, make sure not to pull the blades, in order not to damage them and to avoid any
risk of injury.
10