Checking The Battery Charge Level; Cleaning; Maintenance And Storage - Parkside PLG 20 A4 Instrucciones De Uso

ATTENTION!
♦ If the red control LED
pack has overheated and cannot be charged .
♦ If the red and green control LEDs
that the battery pack
♦ Push the battery pack
♦ Switch off the charger for at least 15 minutes between successive
charging sessions . Also disconnect the power plug from the mains
power socket .

Checking the battery charge level

♦ Press the battery charge level button
battery (see also main diagram) .
The status/remaining charge will be shown on the battery display
LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Cleaning

■ Clean the appliance with a dry cloth or brush . Do not use water
or metallic objects .

Maintenance and storage

■ If you do not intend to use the appliance for an extended period,
remove the batteries and store it in a clean, dry place away from
direct sunlight .
■ 8 │ GB │ IE
flashes, this means that the battery
is defective .
into the appliance .
to check the status of the
both flash, this means
PLG 20 A4