GE Evolve Guia De Instalacion página 2

1
UNPACKING
• This luminaire has been properly packed so that no
parts should have been damaged during transit.
• Inspect to confirm.
2
HANDLING
• Damage may occur if luminaire is improperly handled
outside of pack.
• Do not impact or stack luminaire after removal from
packaging.
3
MOUNTING
Risk of injury or damage. Unit will fall if not installed
properly. Follow installation instructions.
A. Before Installing:
1. Drill a 4" open hole in the ceiling to mount fixture. If the
size of open hole in the ceiling is less than 4", enlarge
the open hole to 4". (See Fig.1)
2. Clean all areas that will be sealed.
B.
Lift the luminaire to the 4" open hole. Pass wires or
cables through the ceiling. Do not pinch or trap wires
between luminaire and ceiling. (See Fig.2)
WARNING
FIGURE 1
FIGURE 2
C.
Mount the luminaire using the provided hardware. Use
30in-lbs of torque for the mounting screws (do not over
tighten or strip screws). If ceiling material is 22ga or
lighter, an accessory backer plate is recommended.
(See Fig.3)
Electrical
A. From above, make electrical connections.
1. Connect power to luminaire where Black is Line, White
is Neutral and Green is Ground. Replace the electrical
access plate with gasket seated against fixture and
fasten with provided hardware. Use liquid tight fittings
(not supplied) to form a weather tight seal to luminaire.
2. If ordered with accessory junction box, mount the
junction box to the top of the fixture using provided
hardware, connect lead wires same as above. Replace
Junction box cover with all provided gaskets. Use liquid
tight fittings (not supplied) to form a weather tight seal
to luminaire.
Notes:
• This product must be installed in accordance with
applicable local, state, and national electrical codes
by a licensed person familiar with the construction
and operation of the product and hazards involved.
• This luminaire must adequately grounded for
protection against shock hazards and to assure
proper operation.
• Make sure all electrical power is turned off while
installing the fixture.
• If the supply wire is damaged, it must be replaced by
the manufacturer or its service agent or a similar
qualified person in order to avoid a hazard.
• The structure of Installation of this lighting needs to
afford load of 20 pounds. To avoid fixture fall.
• Fixture recommended installation height of 16 feet
or above.
FIGURE 3