UFESA CE7165 Instrucciones De Uso página 10

Press the steam button (13). When the ON/OFF
button stops flashing, the right temperature for
steam will have been reached.
2. Place a container below the steam nozzle
(3) and turn the steam regulator (14) in an
anti-clockwise direction (Fig. 4). After any water
left in the nozzle has been cleared out, close it.
Insert the nozzle into the jug of milk and turn the
steam regulator back on so that steam comes
out (Fig. 5).
3. Move the jug up and down slightly. Avoid
letting the liquid go beyond the end of the nozzle
as this will stop air from being drawn in. Place
the steam pipe just above the surface of the milk
in order to make it frothy. Add the frothed-up milk
to the coffee.
IMPORTANT: After making froth clean off any
milk left stuck to the nozzle. Giving it a further
short burst of steam will help to clean it.
4. Clean the steam nozzle regularly with the
appliance unplugged and cold (Fig. 6).
Remove the sleeve (3a) from the steam pipe (3)
and clean out the nozzle with soft damp cloth.
The sleeve can be washed under running tap
water.
SWITCHING FROM CAPPUCCINO
TO ESPRESSO
If you decide to make coffee again after having
used the steam function, the water in the
machine will be too hot for brewing coffee. To
bring the temperature down press the steam
button (13) to switch off the steam production,
allowing the coffee maker to cool down.
Now, press the manual espresso button (10)
and, at the same time, turn the steam regulator
(14) on, allowing water to come through the
steam nozzle until the ON/OFF button lights up
again.
Turn the steam regulator off.
FILLING THE WATER BOILER
If the water boiler is empty, no steam will come
out from the Steam Nozzle. Follow these
instructions to fill the water boiler:
1. Disconnect the appliance from mains
supply.
2. Fill the water tank with cold water.
3. Connect the appliance to a suitable mains
supply outlet, the appliance will be switched on
with a deep sound and the ON/OFF button lamp
flashes.
4. Place an empty container under the filter
reception (17).
5. Press manual espresso button to allow half
water in the water thank to run through.
6. The boiler is filled.
AUTO SHUT-OFF FUNCTION
The appliance will switch off automatically if it
has not been operated for 1 hour. Press ON/
OFF Button (9) to restart the appliance.
HOW TO MAKE HOT WATER FOR
TEA OR HOT DRINKS
1. Press the ON/OFF button (9) and the steam
button (13). The ON/OFF button will flash. When
it stops flashing, the coffee maker has reached
the right temperature.
2. Place a cup below the steam nozzle (3) and
press the manual espresso button (10). Then
turn the steam regulator (14) on so that hot
water comes through the steam nozzle.
CLEANING & MAINTENANCE
Make sure that the coffee maker is unplugged
and cold before attempting to clean it.
The detachable parts can be washed in soapy
water. Do not immerse the coffee maker in water
or any other liquid.
With a damp cloth periodically clean out the area
where the filter holder sits, so as to remove any
coffee that may have become stuck to it.
Be careful when removing the filter holder as
there may be hot water left inside it.
In order to prolong the life of the machine, do not
refit the filter holder if the coffee maker is going
to be stored away for prolonged periods. Do not
clean any of the parts in the dishwasher.
DESCALING
The coffee maker should be descaled regularly.
To do this, fill the tank with a mix of three parts
water to one part vinegar.
Operate the appliance for two cycles, including
the steam pipe.
Following this, and to flush out any traces of
vinegar, operate the coffee maker for a further
two cycles but with water only.
In order to obtain optimal results, it is also
possible to add descaling liquid instead of
vinegar into the water tank of the machine. To
clean the coffee maker with this descaling liquid
you must read carefully the instructions given by
the manufacturer of the descaling product.
POSSIBLE FAULTS AND THEIR
SOLUTION
The espresso coffee is not hot enough:
- Warm the cups up beforehand.
- Descale the coffee maker.
The flow rate is reduced considerably:
- Try putting less coffee in the filter.
- Use a coarser ground coffee, or pack the
coffee down less.
- Descale the coffee maker.