Worx WG509 Manual De Uso página 7

1. HANDLE
2. ON/OFF SWITCH
3. RELEASE BUTTON
4. UPPER VACUUM TUBE
5. LOWER VACUUM TUBE
6. DEBRIS COLLECTION BAG
7. BLOWER TUBE
8. BLOWER/VACUUM SELECTOR LEVER
9. QUICK RELEASE BAG COLLAR
10. MOTOR HOUSING
11. EXTENSION CORD HOLDER
12. VARIABLE SPEED SWITCH
Not all the accessories illustrated or
described are included in standard de-
livery.
TECHNICAL DATA
Rated voltage
Rated power
No load speed
Airflow
Air speed
Mulching ratio
Collection bag
capacity
Weight
Protection class
12 AMP All-in-One blower/vac/mulcher EN
120V ~ 60Hz
12A
6000-15000/min
350cfm
80-210mph(128-335km/h)
18:1
1.2Bushels(42L)
9.3 lbs(4.2kg)
/II
ACCESSORIES
WG509 WG509.1 WG509.2
Leaf Collection
Bag
High Capacity
Universal Leaf
Collection System
(WA4054.1)
We recommend that you purchase your
accessories listed in the above list from the
same store that sold you the tool.Refer to the
accessory packaging for further details. Store
personnel can assist you and offer advice.
Only use the appropriate accessories intended
for this tool. Accessory information can be
found on the product packaging, at a WORX
dealer or on our website at www.worx.com.
ASSEMBLY
ASSEMBLING THE BLOWER/VACUUM
TUBE (See Fig. A, B, C)
Before assembling the Blower/Vacuum Tube,
be sure the on/off switch (2) is in position ''O'
and the tool is unplugged.
First align the upper and lower tubes as shown
in Fig A. Make sure the notches engage the
holes on both sides.
Then fit the Blower/Vacuum Tube to the motor
housing as shown in Fig. B and C.
Position the bottom of tube on the motor
housing near the switch lever. (See Fig B).
Then as seen in Fig C, swing the top of the
Tube upward and lock into place. Check the
Blower/Vacuum Tube is firmly secured.
WARNING! Do not attempt to
operate or disable the on/off
switch.
NOTE: After attaching the Blower/Vacuum
Tube to the motor housing (10), you may later
remove it by moving the On/Off switch to the
off position. Then press the Release Button
(3), in order to release the tube. Do not try to
separate the tubes by force or by using tools,
unplug the tool before separating the tube.
1 1 2
/ 1 /
7