Worx WG509 Manual De Uso página 8

ATTACHING THE DEBRIS COLLECTION
BAG (See Fig. D1-D3)
The TRIVAC is equipped with a Debris
Collection Bag (6), which is designed for
collecting leaves and debris. Attach the Debris
Collection Bag as shown in Fig D1 – To install
the Debris Collection Bag, just align Quick
Release Bag Collar slots with the locking pins
on the motor housing and push the collar
up into position. To release, just depress the
Quick Release Button (a) and pull the Debris
Collection Bag down.
OPERATION
CONNECTING TO A POWER SOURCE
Use only a polarized (i.e., one blade is wider
than the other), UL listed (CSA certified in
Canada) extension cord recommended for
outdoor use. A polarized plug will fit in a
polarized cord only one way. If the plug does
not fit fully in the cord, reverse the cord and
try again. If it still does not fit then you are not
using a proper extension cord and you should
8
purchase a polarized extension cord. Never
attempt to force fit an extension cord or change
the cords design to make it fit better.
Extension Cord
Length
100ft.
150ft
NOTE: Do not use an extension cord over
150 feet.
If you do not fully seat the extension
cord on the inlet plug, the loose plug
could lead to overheating and cause a
fire, possibly burning you or others.
Ensure that you fully seat the cord on
the plug and use the cord lock feature to
secure the cord.
IMPORTANT: Check the power cord
frequently during use for holes in the
insulation. Do not use a damaged cord. Do not
run the cord through standing water or wet grass.
STARTING/STOPPING (See Fig. E)
IMPORTANT: The TRIVAC will not run
unless the Blower/Vacuum Tube is
12 AMP All-in-One blower/vac/mulcher EN
Minimum Wire
Gage (A.W.G.)
14
12
attached to the Motor Housing (10).
Starting
STARTING
Connect the plug to the power outlet and
switch ON by moving the On/Off switch to
position "I" .
STOPPING
Move the On/Off switch to position "O" .
WARNING! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down or removing the
debris collection bag.
CONVERTING FROM BLOWER TO
VACUUM (See Fig. F)
For selection of the operating mode, rotate
the Blower/vacuum selector lever (8) to the
required symbol (see Fig F).
Blowing operating mode
Vacuum operating mode
USING THE BLOWER (See Fig. G)
The blower is intended for residential use
only. Use the blower outdoors to move or
vacuum yard debris as needed.
CAUTION!
The blower can throw debris, possibly
causing serious personal injury to the
operator or bystanders.
Do not blow hard objects such as
•
nails, bolts, or rocks.
Do not operate the blower near
•
children, bystanders or pets.
Use extra care when cleaning debris
•
from stairs or other tight areas.
Wear safety goggles or other suitable
•
eye protection, long pants, and
shoes.
VARIABLE SPEED SWITCH (See Fig. H)
The speed of the blower can be altered by
rotating the Variable Speed Switch (12). Rotate
upward to decrease speed and downward to
increase speed. Position 1 is the lowest and
Position 6 is the highest speed.