Agilent Technologies Medalist i1000 Manual Del Operador página 11

1 If required, double- click in the fields in the Test Setup area
2 Place the board under test on the test fixture.
3 On a press down model, press both DOWN buttons (a).
(a)
Medalist i1000 Operator Guide
Pinch hazard.
WA R N I N G
When testing starts, vacuum or compressed air is applied to
the fixture. To avoid pinched fingers, keep fingers away from
the PC board and test fixture.
enter the Serial Number, Work Shift, and Board Name. You may also
scan in the information if you have a barcode scanner.
On a vacuum model, close the top cover of the fixture and press the
TEST1 button (b).
Depending on the setup of the tester by the test engineer, testing either
starts automatically when the fixture is engaged, or the system waits
for you to initiate the test.
(a)
(Figure 3) to
(b)
9