Metra 95-5812 Manual De Usuario página 10

ISO DIN radio provision with pocket
1. (a) For the Ford Econoline 2009-up,
Edge 2007-2010, Expedition 2007-2014,
Expedition (fleet) 2015, Explorer
& Explorer Sport Trac 2006-2010,
F-650/750 2011-up, F-250/350/450/550
2008-2016, F-150 2004-2008, Fusion
2006-2009, Transit Connect 2012-2013 /
Lincoln Mark LT 2006-2008, MKX (with
NAV) 2007-2010, Navigator (with NAV)
2007-2014 / Mercury Milan 2006-2009,
Mountaineer 2006-2010, attach the
spacers to the mounting tabs on radio
housing B. Use the (4) screws provided
to secure the radio housing to the
vehicle. (Figure A)
(b) For the Ford F-250/350/450/550
2005-2007, Focus 2005-2007, Freestar
2004-2007, Monterey 2004-2007, slide
the side brackets onto the sides of radio
housing B. (Figure B)
Note: If your vehicle is not listed in steps
(a) or (b), proceed to Step 2.
10
KIT ASSEMBLY
(Figure A)
(Figure B)
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Mount the ISO brackets to the radio
with the screws supplied with the radio.
(Figure C)
4. Slide the radio into the radio opening
until the side clips engage. (Figure D)
5. Snap the trim plate into radio housing B.
(Figure D)
6. Locate the factory wiring harness and
antenna connection in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
7. Reassemble the dash in reverse order of
disassembly.
(Figure C)
(Figure D)
|
1.800.221.0932 MetraOnline.com