Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets
A
B
Metra. The World's Best Kits.
®
Lincoln Navigator
Intended for 4x2 models without factory NAV
KIT FEATURES
• ISO DDIN radio provision
• Painted silver to match the factory appearance
MetraOnline.com
2007-2014
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
95-5844S
I N S TA L L AT I O N I N S T R U C T I O N S
TABLE OF CONTENTS
Dash Disassembly ..................................................2
Kit Preparation .......................................................3
Kit Assembly ..........................................................3
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: Please visit metraonline.com for
interface options
Antenna Adapter: 40-CR10
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• 8mm, 7/32" and 9/32" socket wrench
• T-20 Torx driver
CAUTION!
All accessories, switches, climate
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
REV. 5/14/18 INST95-5844S
Publicidad
Tabla de contenido
Manuales relacionados para Metra 95-5844S
Resumen de contenidos para Metra 95-5844S
- Página 1 Also, do not remove the factory radio with the key in the on position, or while the vehicle is running. Metra. The World’s Best Kits. MetraOnline.com ® © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 5/14/18 INST95-5844S...
-
Página 2: Dash Disassembly
DASH DISASSEMBLY 1. Unclip and remove the panel surrounding the shifter. (Figure A) 2. Remove (2) 9/32” screws from the bottom of the radio/climate control trim panel, and then unclip and remove. (Figure B) 3. Remove (4) 9/32” screws securing the radio and then remove. -
Página 3: Kit Preparation
(Figure A) complete all necessary connections to 2. Mount the pocket, climate controls and the radio. Metra recommends using the buttons to the Metra radio trim panel proper mating adapter from Metra and/ using the factory hardware. (Figure B) or AXXESS. - Página 4 Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow. Metra recommends MECP certified technicians Metra. The World’s Best Kits. MetraOnline.com ® © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 5/14/18 INST95-5844S...
-
Página 5: Lincoln Navigator
Además, no quite el radio de fábrica con la llave en la posición o de encendido ni con el vehículo funcionando. Metra. The World’s Best Kits. MetraOnline.com ® © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 5/14/18 INST95-5844S... -
Página 6: Desmontaje Del Tablero
DESMONTAJE DEL TABLERO 1. Desenganche y quite el panel que rodea la palanca de velocidades. (Figura A) 2. Quite (2) tornillos de 9/32” de la parte inferior del panel de la moldura de control del radio/clima; posteriormente, desenganche y retire. (Figura B) 3. -
Página 7: Preparación Del Kit
(Figura A) presión que retiró en el desensamblado 2. Localice el arnés de cableado de del tablero. (Metra sugiere un conector fábrica y el conector de la antena en el pequeño de 8 mm para colocarlos a tablero y realice todas las conexiones presión). - Página 8 800-354-6782 para obtener más información y avance hacia un futuro mejor. Metra recomienda técnicos con certificación del Programa de Certificación en Electrónica Móvil (Mobile Electronics Certification Program, MECP). Metra. The World’s Best Kits. MetraOnline.com ® © COPYRIGHT 2018 METRA ELECTRONICS CORPORATION REV. 5/14/18 INST95-5844S...