Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ISO DDIN radio provision
1. Attach the ISO DDIN brackets to radio
housing A. (Figure A)
2. (a) For the Ford Econoline 2009-up,
Edge 2007-2010, Expedition 2007-
2014, Expedition (fleet) 2015, Explorer
& Explorer Sport Trac 2006-2010,
F-650/750 2011-up, F-250/350/450/550
2008-2016, F-150 2004-2008, Fusion
2006-2009, Transit Connect 2012-2013 /
Lincoln Mark LT 2006-2008, MKX (with
NAV) 2007-2010, Navigator (with NAV)
2007-2014 / Mercury Milan 2006-2009,
Mountaineer 2006-2010, attach the
spacers to the mounting tabs on radio
housing A. Use the (4) screws provided
to secure the radio housing to the
vehicle. (Figure B).
KIT ASSEMBLY
(Figure A)
(Figure B)
(b) For the Ford Five Hundred 2005-
2007, Freestyle 2005-2007, Mustang
2005-2009, Taurus & Taurus X 2008-
2009 / Mercury Montego 2005-2007,
Sable 2008-2009, cut and remove the
rear mounting tabs from the brackets.
(Figure C)
Note: If your vehicle is not listed in steps
(a) or (b), proceed to step 3.
3. Slide the radio into the radio housing
and secure using the screws supplied
with the radio. (Figure D)
4. Locate the factory wiring harness and
antenna connection in the dash. Metra
recommends using the proper mating
adapter from Metra or AXXESS. Test the
radio for proper operation.
5. Reassemble the dash in reverse order of
disassembly.
(Figure C)
(Figure D)
REV. 3/22/2019 INST-5812
11
Publicidad
Tabla de contenido
