Cleaning The Rinsing Pump; Replacing The Rinsing Pump; Replace The Aerator Rod - Oase ProfiClear Premium Compact L Instrucciones De Uso

Fitting
How to proceed:
 V, W
Before fitting the filter drum check that the drum seal is undamaged and correctly positioned. Lubricate
the seal with the supplied grease. Replace the drum seal if damaged.
1. Fitting a new drum seal: Ensure that the recess in the drum seal is at the top.
2. Ensure that the separating plate is completely seated in the groove of the drum seal.
► Continue to assemble in the reverse order.
8.7

Cleaning the rinsing pump

It is often possible to remove soiling from the rinsing device and rinsing pump by cleaning the rinsing
device without the nozzle/nozzles.
► Remove the nozzle/nozzles for cleaning so that the dirt particles are flushed out.
Remove the inner cover to allow work to be carried out on the rinsing pump.
How to proceed:
 X
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Lift the rinsing pump, remove the rubber ring and filter sock.
– Clean all parts in clean water.
8.8

Replacing the rinsing pump

Remove the inner cover to allow work to be carried out on the rinsing pump.
How to proceed:
 Y
1. Undo the fastening device. To do this, unhook both rubber straps.
2. Loosen the union nut and disconnect the hose.
3. Take out the rinsing pump and replace.
– Disconnect the connection cable from the cable harness.
4. Fit the rinsing pump in the reverse order.
8.9

Replace the aerator rod

How to proceed:
 Z
1. Remove approx. 2/3 of the Hel-X bio-elements and keep moist. After completing the maintenance
measures, return the Hel-X bio-elements to the container.
2. Pull the aerator rod out of the clamping holder at the bottom of the container.
3. Disconnect the hose from the aerator rod and fit it onto the new aerator rod.
4. Press the new aerator rod into the clamping holder.
- EN -
75