Resetting
If the system does not respond or exhibits erratic or intermittent operation, you may have
experienced an electrostatic discharge (ESD) or a power surge that triggered the internal
microcontroller to shut down automatically. If this occurs, simply disconnect the ac power cord
and remove the system backup battery, wait for at least 3 minutes and then setup the unit again
as if it is a brand new unit.
Specifications
Frequency range :
Battery backup :
Power supply :
Hereby, Wörlein GmbH declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
A copy of the Declaration of Conformity may be obtained at the following location: Wörlein
GmbH, Gewerbestrasse 12, D 90556 Cadolzburg, Germany
Importer
Wörlein GmbH
Gewerbestrasse 12
D 90556 Cadolzburg
GERMANY
Specifications are subject to change without further notice.
Copyright by Wörlein GmbH, D 90556 Cadolzburg.
FUR6100SI / English Instruction Manual
87.5 – 108 MHz
3V (CR2032 Flat Lithium battery x 1) not included
AC230V 50Hz
Tel.: +49 9103 71 67 0
Fax.: +49 9103 71 67 12
Email.:service@woerlein.com
Web.: www.woerlein.com
8