Preparing For Hot Lamination - UNITED OFFICE ULGD 350 A1 Instrucciones De Uso

Preparing for hot lamination

GB
MT
50
♦ Insert the document support
slot , such that it is seated fi rmly on the appliance.
♦ Insert the plug of the laminator into a mains power socket.
♦ Switch the appliance on by placing the selector switch for hot and cold
lamination at "HOT". The red indicator light Power
5
♦ Place the pouch thickness switch
(see also chapter Switching levels).
NOTICE
► The attainment of the operating temperature is indicated by the glowing
of the green indicator light Ready
we recommend, especially for thinner foils (below 125 Micron), and after
adjustment to a diff erent foil thickness, to fi rst wait an additional 2-3 minutes
before beginning with lamination.
♦ Place the document to be laminated into a laminating pouch of the
appropriate size.
NOTICE
► Ensure that all edges of the document have at least two millimetres of
space to the edges of the laminating pouch, as shown in Fig. 1.
► Ensure that you use only one pouch for laminating. First open it up, as
shown in Fig. 2.
► For further information about the lamination process, please read the
section Lamination process.
Fig. 1
Fig. 2
into the two openings under the pouch ejector
at the corresponding pouch thickness
4
. For a more uniform laminating result
2
3 glows.
ULGD 350 A1