Preparing For Hot Lamination - UNITED OFFICE ULG 350 B1 Instrucciones De Uso

Preparing for hot lamination

♦ Insert the plug of the laminator into a mains power socket.
♦ Switch the appliance on by pushing the On/Off switch
tion. The red Power indicator light
♦ Set the selector switch for hot and cold lamination
♦ Place the pouch thickness switch
(see also chapter Switching levels).
NOTICE
► The attainment of the operating temperature is indicated by the glowing
of the green indicator light Ready
we recommend, especially for thinner foils (below 125 Micron), and after
adjustment to a different foil thickness, to first wait an additional 2-3 minutes
before beginning with lamination.
♦ Place the document to be laminated into a laminating pouch of the
appropriate size.
NOTICE
► Ensure that all edges of the document have at least two millimetres of
space to the edges of the laminating pouch, as shown in Fig. 1.
► Make certain that you use only one pouch for laminating. First flip it up, as
shown in Fig. 2.
► For further information about the lamination process, please read the
section Lamination process.
Fig. 1
Fig. 2
GB │ IE
│
■ 22
lights up.
2
to "HOT".
6
at the corresponding pouch thickness
4
. For a more uniform laminating result
3
to the "ON" posi-
5
ULG 350 B1