GreenWorks CS-80-XR-T Manual Del Propietário página 15

OPERATION INSTRUCTION
W A R N I N G
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is
damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery pack.
• Verify that the battery pack is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the pole saw.
• Read, understand, and follow the instructions contained in the section entitled Charging
Procedure.
I M P O R T A N T
This Lithium-ion battery pack is equipped with an internal circuit breaker which will automatically
shut off the power to the tool and then reset itself once cooled.
Follow these steps if an overload occurs while under heavy use:
1. Release the power switch and restart tool by depressing switch.
2. The battery may need to be removed for approximately 1 minute, allowed to cool and then
reinstalled for use.
STARTING AND STOPPING (See Figure 7)
TO START THE MOTOR:
• Fit the battery pack into the pole saw.
• Press and hold the switch lock. This makes the switch trigger operational.
• Press and hold the switch trigger, release the switch lock and continue to squeeze the switch
trigger for continued operation.
TO STOP THE MOTOR:
• Release the switch trigger.
Safety lock
Switch Trigger
15
Fig.7