Reusable Cloth Filter; Wet Pick Up Operation - Craftsman CMXEVCVVJC507P Manual De Instrucciones

cloth filter is necessary to pick up dust. If the
reusable cloth filter is wet, it will clog quickly
and be very difficult to clean. Handle the filter
carefully when removing it for cleaning and
replacing it. Check the filters for tears or small
holes. A small hole can let dust pass through
and out of the filter. Do not use a filter with
holes or tears; replace it immediately.
INSTALLING AND CLEANING THE

REUSABLE CLOTH FILTER:

WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
16. Remove the power head and place in an
upside down position.
17. Install the reusable cloth filter
the filter cage making sure the cage is
completely covered. Fig. 8.
Fig. 8
18. With the removed power head in an
upside down position, carefully remove
the reusable cloth filter
cage. Fig. 9.
Fig. 9
VERIFY THAT THE
14
over
14 from the filter
19. Clean the reusable cloth filter
tapping or brushing dirt off. Use a mild
soap and water solution to wash reusable
cloth filter and rinse with clean water.
CAUTION:
NOT BE DONE INDOORS IN LIVING AREAS.
FOR OPTIMAL PERFORMANCE A NEW
FILTER IS RECOMMENDED.
EMPTYING DRY WASTE FROM
THE TANK
WARNING:
POWER CORD IS DISCONNECTED FROM THE
OUTLET.
20. Disconnect the hose
Undo the latches
2 from the collection tank. Fig 10.
head
Place power head on soft, clean surface
upside down. Clear all dirt or debris from
the collection tank and hose. Place power
head back onto the collection tank and
secure latches.
Fig. 10

Wet Pick Up Operation

IMPORTANT! When vacuuming large quantities
of liquids, do not immerse the nozzle
completely in the liquid; leave a gap at the tip
of the nozzle opening to allow air inflow. The
machine is fitted with a float valve that stops
the suction action when the collection tank
reaches its maximum capacity. You will notice
an increase in motor speed.
ENGLISH
14
by gently
CLEANING SHOULD
VERIFY THAT THE
11
from the vacuum.
4 and remove the power
7