decorflame MM637L-42GWL Manual Del Usuario página 5

OPERATION BY THE CONTROL PANEL
The controls are located at the right corner of the insert.
0/i:
Press this button for main power function. The unit will beep and the indicator
light will be on. Press again will stop the main power function.
: To adjust the temperature to your individual requirements, turn the temperature
control dial to the right (clockwise) to increase the desired temperature and to
the left (counter-clockwise) for lower temperature. This temperature control dial
can only be used while the O/I switch and 750W & 1500W switches are in the ON
position.
Note: When the O/I switch is turned off, all other heater functions will stop even though
the switches may be in the on position.
Note: In order to shut down the heater safely, it is recommended to turn the temperature
control knob to lowest setting and allow the heater to cool down before press the O/I
switch to off position.
OPERATION BY THE REMOTE CONTROL
Plug in your electric fireplace and turn the O/I button to on position.
This means you have power and your remote is ready to operate
your electric fireplace.
: Press this button to turn ON the fireplace. The unit will
beep. Press again to off the fireplace and the fan will
continue to work for 5 seconds without heat.
: Press this button once for flame effect. The unit will beep.
Press again to increase the flame intensity. There are 6
light intensities for your selection. The flame optics will
go higher under the sequence of OFF, 1, 2, 3, 4, 5 and 6.
Pressing the button again will stop the light function.
750w: Press this button for low heat level. The indicator light will be ON.
The fireplace heater will give low heat level. Press once again will
stop the low heat level function.
1500w: Press this button for high heat level. The unit will beep. The fireplace heater will
give high heat level. Press once again will stop the high heat level function.
REMOTE CONTROL BATTERY REPLACEMENT
Replace with a CR2025 battery and follow the diagram at the back of remote control to
install the new battery.
MAINTENANCE
warNiNG: DiScONNEct pOwEr aND UNplUG tHE pOwEr cOrD BEFOrE attEMptiNG aNy
MaiNtENaNcE Or clEaNiNG tO rEDUcE tHE riSk OF FirE, ElEctric SHOck Or DaMaGE
tO pErSONS.
REPAIR SET
TOUCH-UP REPAIR PAINT
Paint directly on the mantel unit if necessary.
REPAIRS
If any problems are found with the original parts during mantel assembly such as the
panels cannot be installed with the plastic connector. Try to solve by one of the following
methods.
Tools required: Electric drill, drill bit 10 mm (3/4 in) or 2 mm (1/16 in), pencil, hammer,
Phillips screwdriver, safety goggles and gloves (if necessary).
warNiNG: wEar GOGGlES BEFOrE yOU Start DrilliNG.
OptiON 1:
Use the spare nuts, screws and plastic connector.
750W 1500W 1. Place the plastic connector on the mantel unit and mark the drill-holes, as shown in
Fig. A.
5
Fig. A